Overview
6hp
Kanal is a waveshaper that works by sculpting a canal out of the middle of a waveform.
Basic Operation
Send a signal to the input. The ATT Parameter applies gain to the signal (-2x to 2x).
The P Parameter controls the position of the center of the canal (-2.5 volts to 2.5 volts).
The W Parameter controls the width of the canal (0 no effect, to 5 volts from the bottom to
the top of the canal).
The TB Parameter controls the amount of Top Boost, this is a multiplier applied to the waveform above the canal. Negative values will invert the waveform back into the canal.
The BB Parameter controls the amount of Bottom Boost, this is a multiplier applied to the waveform below the canal. Negative values will invert the waveform back into the canal.
The shaped waveform is sent to the OUT output.
The X-0 output will fire a trigger when the input signal crosses 0 volts.
